Bought this from RC Bazaar

It's a powered glider (sailplane type) with a T-tail.

Well packed, good laser cutting and a comprehensive hardware kit. And, the icing on the cake: a full size rolled (not folded!) drawing!

Brief Specs:
Wingspan: 1550mm (61")
Fuselage Length: 820mm
Flying weight: about 650g

Motor 2212-1100 KV recommended, I'm using a NTM 2830-1100 KV with 30 A ESC
LiPo: 1300 - 1500 mAh
Servos 9 gm all round (4 Nos.)
Prop: 8*4 folding prop

Very comprehensive hardware package includes an X Mount and a screwdriver 

However, they didn't include blind nuts for motor mounting to the firewall 

Balsa and ply is of good quality and well selected. Laser cutting is the best I've seen so far from these kits

Important to do tril fit of both the sub-assembly one is building plus the next in sequence

Not a good idea to depend overly on these instructions

I had to reverse the motor shaft. Cut a groove for the circlip and ground a flat for the grub screw

The vertical stab is pretty strongly designed - it carries the horizontal stab too.

The Elevator pushrod goes through the vertical stab

The fuse boom is a separate part (to be affixed later) with conventional balsa frame plus a carbon fibre tube for strength. The pushrods go through this tube

Next: sheeting wings

Subscribed 

 

Very good going sirji

Thank you Gaurang