I had made a Birdie 10 a year ago, but was not happy with the build, or the performance. Am trying again with some modifications

Details. I will be using an NTM 2836-1400 KV motor, 40 A ESC, 9*6 e-prop, and 2200 mah LiPo

Firewall

Best of Luck!. That's the same power setup I'm using on the AviSport. Keep the weight to 1000-1100g and you will have plenty of power and speed. 

I know you are using that, obviously 

And I know the weight, again - obviously 

Thanks, Maahin

Are you using cyno for pasting sir

Dev, in a Corro build I typically use 4 different adhesives:

1. For general use, Cyano
2. For stressed areas like firewall or landing gear base plate wood to corro, 5 minute Epoxy
3. For large flat surfaces which would be difficult to clamp down, or use cyano (as it would dry on one side by the time I finish applying on the other) or which need some flex in the joint, Fevicol SR 998 - a rubber based adhesive. Typically when I am gluing the wing edge after folding over. I don't need to clamp to dry
4. For fillet joints (two surfaces at right angles to each other) I use hot glue e.g. vertical stab to fuselage

Thank u sir...  And I dn know how to alight vertical stab to the fuse

What about the thickness of coro sir

Here the tail section & ailerons are 4 mm, rest 3 (actually 2.7 mm)

My kind request sir... Pls tell about ur... Coro thickness... In ur build logs

nice

Keenly waiting for this plane.

Nice

 

Thanks everyone 

Sir, +1 for the build and + 10 for the godspeed you possess.