This is from Outer Zone, a RCM design by Dick Tichenor circa 1982

Link: http://www.outerzone.co.uk/plan_details.asp?ID=6545

Specs:

Made a few changes - reduced the fuse height to 5"from 6"(not counting canopy) and of course being a Corro model, the internals are entirely different. Retained the other dimensions, and wing/stabilizer shapes

Firewall and 2 formers

FW is 12 mm ply, formers are 4 mm

Nice plane sanjay sir...  Looking forward for the complete plane..

Someday I wanna come and learn the marking tricks from you sir..

Thanks Dev

You are always welcome

Love those neat circular cutouts in the formers...

Iyer sir's eye for detail 

Very well sanjay sir your fuselage sides cutting is very neet and clean what blade you use for coro cutting paper cutting blade or exacto knife again very well done sir

Thanks Gaurang

I use an ordinary "box-cutter"type hobby knife, nothing special

Fuselage is from 5mm corro

Small box for throttle servo

Testing & Centering the servos, cute little Instrument I got as a Birthday Gift

Fuel contact areas fuelproofed with enamel paint

Subscribed.....Wonderful build Sanjayji.

Thanks buddy

Still a long way to go........

Pretty involved tail build, the horizontal stab has a (functional) aerofoil. This is as a little extra lift on the tail is integral to the design. The stab span is also 25 1/4", so rigidity is important. The same holds true for the vertical stab, which is also massive

Decided to go for a built-up horizontal stab, and to use 4 + 2.5 mm corro at 90 degrees for the vertical

Thermocol in the wing-tips.This is then coated with a thin layer of epoxy to make it fuel and (other) corrosive adhesive proof