Here I'll post the Unboxing and Build Pics with Explanation Required.
It's a 480 size Helicopter . Not like the stretch ALIGN or Other . All Different ! And All BELT.

I Bought the kit from RC711 (http://www.rc711.com/shop/compass-warp-360-fbl-3d-helicopter-combo-ur3-green-wmotor-blades-p-6984.html?cPath=165_146_355)
With Blades and Stock Motor Combo .

Planning to run
-Stock Motor
-YEP 60 Amp ESC
-Castle BEC
-TGY 306HV Servos for Cyclics and Tail
-KBar Gyro (VBar clone) (http://www.rcbazaar.com/products/2327-avionic-kbar.aspx)

-Main Rotor Spin Blades
-Tail Rotor Edge Blades

The Build Won't be fast , Quite a time consuming Build . As you can see the No. of parts
The Manual comes in a PenDrive .

It comes with a 16T Pinion But I'll be running on a 18T.


UNBOXING







Comes nicely packed . Canopy's safe
Parts All over my table 










Blades




Electronics
Tail Servo in Transit !


All I can Say - Best 450 Sized Helicopter Available 

wow!! i am jealous by all the helicopters!!
all the best

Lots of tits bits to be put in. Not a straight build.

Hahaha Thanks Sujit Sir
You can join the show anytime

Doc seriously Best and hardest to build

Now that's some thing different & BIG TOY MAN BIG TOY

INSANE ~ INSANEEEE C O M P A S S WARP 360 BABY

I'll do a maiden

So after these days I actually started the build . I'll be slow cause i still got exams comin through .

So the kit comes with a Pendrive with Manual and Time-Lapse video inside which is pretty cool.
And this Heli is special to me .
Starting with the head which doesn't have feathering shaft  But definitely still got the bearing and Thrust bearing .

The screws were oily , so I used Acetone for cleaning them





HEAD Assembly





The bearing and thrust bearing comes preinstalled but suggested to take out and grease them
Do check the Manual for re-installing . Few Guys required sanding of the hub for smooth movement .
Also the blade grips have play which has nothing to worry . Totally normal

 

The Swash Feels heavy . No play at all but required little Oiling on the bearing .
The linkage balls are pre-thredlocked .





The DFC linkage needs to be Measured and installed according to the manual .
Requires ball link resizer or just take them out and install again and again. Will make them smooth

Then the Tail Assembly now . I missed clicking many times .
There is 1mm Gap in-between the Tail Case Frame which is okay-okay after assembly . Can't notice









Now had to pass the belt through the Boom

Now the Cyclic servos installation .

The Belt Tightener
Comes Pre-installed but needs thread lock
Will install later while doing the frame.

Main Drive Gear Assembly

Motor Installation
Need to use the motor center tool to avoid rubbing with motor mount .
Also at this point , need to do exactly as manual says.

Starting the Frame.
Note the elevator installation . I did make mistake while installing .

The Skids

heli is awesome druve

Thanks Dipesh .

Installed the Gyro and RX .
I have installed the DMSS Rx Already . My new Transmitter is in transit so already bought the rx from RcDhamaka. Might get the tx in 10 days . Hope so

Big mistake is that i should have bought the 6ch not the 8ch But still its fine .

   looks good dhruv looks complicated build

Thanks Ram .
Build almost complete . Just need to install the linkages .
Will maiden this week

Awesome dhruva, this looks like a real build log showing each and everything good luck