hi,
i am venkatesh.this is a plane i designed myself and built it just after my exams.

MATERIALS USED:-
WING:- 4MM  LAMINATED FOAM
FUSE:- PVC ELECTRICAL CONDUIT PIPE.
TAIL PLANE:- 3MM CORO
CONROL SURFACES:-3MM CORO(ELEVATOR,AILERON).

SPECS:-
WINGSPAN:- 75CM(2FT15CM)
FUSE LENGTH:-60CM(2FT)
RCFORALL 9GM SERVOS:-2NOS
ASTRO BRUSH LESS IN RUNNER MOTOR 4200KILOWATT/VOLT.(MODEL NO:-803V)
RCFORALL 40AMP BL SPEED CONTROLLER
RCFORALL 1800MAH/11.1V
TOTAL WEIGHT:-500GMS.

SPEED:- NOT YET MEASURED  BUT VERY FAST.

HERE ARE SOME PICS

HERE IS ANOTHER PIC :-
BTW this plane you will see is made of combinations of various building materials like coro,foam,pvc pipe etc.it is because i used a lot of waste  stuff lying around 

hi aeronut

nice plane,when are you planing to maiden it? btw the radio in the first two pictures is a JR 8 channel radio right ? and in the third picture the RX is a futaba R114F that is what i could make out from the picture

if my observation is right your receiver will not work with JR transmitter !

sahil

hi sahilkit,
i have already maidened it and it flies very fast. i put the jr just to add to the baground  .
i also have an futaba 6exap .