Problem charging my LiPo battery

Started by zeuses23, May 08, 2018, 10:42:39 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

zeuses23

So I'm very new to the RC Plane scene and I have done quite a bit of research, but for some reason while testing my electronics whenever i connected my brand new Wolfpack 3S 30C 1800 mAh 11.1V battery, the receiver(HKTR6A V2) for a fraction of a second lit up, but then went dark.

I removed all the servos and tried again a few times, and just once it lit up with a red light, so I guessed that it was working fine, and so was my Flycolor 20A Blue Multicopter ESC.

I then realised that I had completely forgotten to check my battery voltage, and so i hooked it up to my IMAX C403 charger. I couldn't find a lantern battery yet, so I improvised by using a 12V, 900mAh AC adapter. The charger powered up fine, detected my battery also, but it was showing that the battery was at 4.15 V. I tried charging it, and it went on fine, but after a few seconds, it gave beeps and said that it was full. What do i do? Thanks in advance!!

https://imgur.com/a/nG3ABp9

K K Iyer

@zeuses23,
Welcome to the forum.
Please do not post the same msg on multiple boards.
It only creates confusion.
Since you are getting replies to your same msg on the 'beginners zone', I'm locking this thead.