hello everyone
Imma be as brief as possible
One of my drone motors is not spinning. But when I swapped a different motor to the same pin, the motor which was not working spun, and the newly connected one DID NOT. Basically, its a connection problem.
But the mystery is, the motors keep beeping if they do not receive a signal from the FC. Once they get connected to the FC, they stop beeping and if you arm them and increase the throttle, they spin. But mine did not beep, meaning they were connected. Still, when I increased the throttle, the motor struggled to spin. This almost caused a crash, had I not been agile enough to disarm my drone.
Anyone please help me :help: Is it just a normal connection problem? then I can resolder the pins. Or is it a more complicated problem involving the FC's hardware or software? I have crashed my drone once and broke one of the motors. The FC did not get any impact though.
Thank you