BATTERY FUSED?

Started by Fw190, September 17, 2012, 02:33:15 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

Fw190

Hello, my battery terminals accidently touched while soldering with my ESC. before soldering it showed a voltage of 11.14 volts, now after the incident it shows 0.01 volts!. The battery had become warm, and now on connecting it with the charger all 3 cell lights are flashing red.
Plz advise if it has been damaged beyond any used or if can be charged back. It is a brand new Zippy Flightmax 2200 mah 20C battery. What to do?
"Stand with your glasses steady,
This life is a life of woe!
A toast for the gone already,
Three cheers for the next man to go!" - RFC song

vinay

Looks like the internals were shorted and the terminals of the battery may be melted(inside the pack).

Adiboy

May your Battery rest in peace....

rastsaurabh

Usually on shorting there must have been lot of heat and melting generated .... i wonder how it was un noticed....

Adiboy

My Turnigy Battery had cried its way out while shorting... Within minutes I had to throw it away...!

vinay

It happens in a second and terminals melt. It happened on my very first battery :) I tried opening it, soldering it, everything. Finally after wasting more time then the battery was worth, I threw it away :)

KALYANPRODHAN

Have you check each cell voltage ? Does any of the cell puffed ? You have to charge with any mobile charger each cell to build up voltage.
We have to unite and to prove ourself to make indigenous products as well as marketing / Canvasing them. I'm sure we must achieve success if we try unitedly.

saahil

Sahil.


Crabs are just pets you carry around on your groin....

bhaumik

Hey fellas I got one problem,
I recently bought a brand new ZOP Li-Po 2200mAh battery. Then while connecting it to one of the ESCs, +ve and -ve connectors touched each other for a fraction of second. I got a spark. Now, battery is totally discharged it gives 0V in multimeter. Is there any hope remains that this battery can be recovered..??
Waiting for your replies, guys..!!
Please do reply..

anwar

Merged into existing thread on the same issue. Bhaumik - please read this thread.
Hangar : Please see my introduction.
RC India forum and me : About this forum.

vinay

Can you do 1 thing? can you use a multimeter and measure individual voltage of the cells using the balance plug? If it shows 0 for one of the cell and more voltage on the other , it looks like one of the terminals melted.  Either way, Nothing much you can do on such things unless the problem is simple. Unless you have extremely good soldering skills. I dont recommend soldering.


Fw190

Yes my battery really died.... :'( gaya hath se Rs 900
"Stand with your glasses steady,
This life is a life of woe!
A toast for the gone already,
Three cheers for the next man to go!" - RFC song

saahil

+1 for gaya hath se 900.
Sahil.


Crabs are just pets you carry around on your groin....

saahil

next time be more careful.
Sahil.


Crabs are just pets you carry around on your groin....