In my x-charger b6 i feed any amps it takes only 2.4amps and display break down . i feed 2.4 amps it work properly. now i cant charge my 1000 mah or 800mah battery. please help :banghead:
Would you clarify what you mean by "feed any amps"? Do you mean that you cannot enter any other charging rate? What happens when you say the "display breaks down"? Is this a sudden occurrence?
Please give a clear description of your symptoms for anyone to help diagnose your problem.
In charging lipo or any battery i feed any amps and press start/enter to start operation it charge 2.4amps and suddenly display break down.
Had the same problem with my ECO6 , i fed it with a 5amp. homemade power supply . after starting the lipo charge at 2.0amps it showed some error ( vol err ) , i think you are hving the same problem.
Try this start charge at 1c or 1amp , then if it goes well after 10min increase the charge current to 2.0amps .Hope it helps
Hey RC dude,
I think Mr Rao have a different problem, he can't enter a low amp charge rate as the charger would not accept anything below 2.4 amps.
I have no clue about this one ???
charger would not accept anything below 2.4 amps or more than 2.4 amps .........