friends,
i have made my first quad and am using a kk.5.5 blackboard with mystery 30 amps and 1000 kv servos.........on a 450 frame
everything seems fine i have programmed the ESC using the TX RX and when i put the YAW in the minimum to programme the KK 5.5 eveything is still fine.....................but when i get out of the programming thing and put YAW to max ......and try to arm the KK BLACKBOARD nothing happens.............
seen some videos on youtube ......used the throttle knob to arm no success.......can any one help me plzzzzzzzzzzzzzzzzzzzzzzzzz
Can you please post a video on this issue..
Even I had some problems while doing it. Have you reversed any channels on the tx? Is your trim to the lowest position
try putting yaw to the lower right corner and hopefully it should arm unless you have messed something up
Btw... do you mean 1000kv motors?
hi,
ya they are motors 1000kv..................well about the videos i have seen they at times have mentioned the trim to be minimum specially the right side one near the elevator knob................and then press the throttle knob to around 5 o'clock ...............but nothing happens.................................
during this case i have put YAW at max and roll and pitch on 50% on my kk 5.5
Yaw at max is for calibrating motors... get it back to 50% and try what I did
thankx but still same problem...................pitch, roll, yaw at 50% and throttle knob turned to 5 oclock nothing works............
when i programme it everything is fine .............my throttle knob gives max when pulled backwards and lowest when pushed away.............is it ok ....................and in T6 config i have put everything on 50% and if the turn on SWA it gives 100% .........should i change it and put maximum on the knobs
What I did was reversed the throttle and yaw on the tx ... try that out