Thought of building a simple pusher plane. Got idea from here :- https://www.rcgroups.com/forums/showthread.php?2194226-Coro-Corflute-Pusher-Trainer-Plans/page3
Started and (almost )finished within  4 hrs.
I used 3mm Depron instead of Corro.. Used (available )avionic 2800 KV motor, Wolfpack 350 mah lipo, 8*4 GWS prop, 18 amp esc. Wing span 650 cm.Chord 19 cm. Fuse 60 cm. AUW 220 gms. Test flight good, except that it is a bit noisy, may be because I have not finished building fuselage .

Bro,  design is quite inefficient,  but for a beginner plane just for park flying hats off!  For the ingenious prop inside the fuse design. Could you do flight video?  Looking forward to seeing it in flight.

I am not sure if this design is inefficient or not; but it flies really good. Very short runway , flies in a small frontyard like mine. Back from another test flight   ( at this time ) . Modified a little bit- reduced height of fuselage because it flies on 6*5 prop now. Less noise from motor . Wait for the video - tomorrow ,in day light

looking for maiden video

kp

Here is the maiden .


Sorry about the bad landing gear/wheels  Lesson learned:I need to order better /bigger wheels This time used 500 Mah Haiyin Lipo.

 

Clean build...looks a lot better than my first build...
P.s I never got the landing gear right too in my early builds....keep flying