Main Menu

2 servos alierons

Started by Ahmad Ilyas, January 28, 2015, 04:43:46 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

Print
Go Down Pages1
User actions

Ahmad Ilyas

January 28, 2015, 04:43:46 PM
i mde up few planes with alierons using single servo
can anybody tell me how to make alierons using 2 servos

docnayeem

Re:
#1
January 28, 2015, 04:51:07 PM
Just install two separate servos for each aileron and then connect them ( wiring) with a Y connector.. All the best

Ahmad Ilyas

#2
January 29, 2015, 08:50:33 PM
where can i get it and i have never seen y connector in STOCK at rc bazaar

arun.sreelakam

#3
January 29, 2015, 08:58:01 PM
Just wire directly.. connect similar colours.. and you are done.. :)
Turnigy i10|Flysky 9xb|Hoverfly quadcopter|Arduflyer apm 2.5 with gps|Pixhawk|Homemade micro night vapour|Homemade ornithopter(in progress)| Reptile Quad with Gopro Brushless gimbal | Naza v2| APM 2.6 with GPS | Micro quad self made | FrSky| v911 Helis | 1200mm Hexacopter with 5d gimbal | 1300mm x8 With Red Gimbal | 1000mm Octo|

Ahmad Ilyas

#4
January 30, 2015, 02:41:56 PM
sorry i didn't understand

sahilkit

#5
January 30, 2015, 05:16:19 PM
Today might be a great and wonderful day. It depends on you.

sahilkit

#6
January 30, 2015, 05:27:56 PM
See the image, connect two servos via servo Y-harness to receiver channel and install them as shown in the picture. The servo arms act/move/travel in opposite direction.

(Image taken from net)
Today might be a great and wonderful day. It depends on you.

sahilkit

#7
January 30, 2015, 05:40:46 PM
Today might be a great and wonderful day. It depends on you.
Print
Go Up Pages1
User actions