Print Page - Simple design easy to fly plane

Title: Simple design easy to fly plane
Post by: SI74 on March 24, 2016, 12:28:09 AM

Motor :1200 KV Avionic outrunner
ESC :Avionic 20 Amp
Lipo: Turnigy 500 Mah 2S
Servos : 3.7 gm *2
TxRx : Turnigy 5 ch
AUW :225 gm
Propeller : 8*6 Slowfly
Wing: span -69 cm chord-22.5 cm
Building material : Depron, HotGlue
Flying characteristic : Superb!
Beginner easy to fly model.
Colour scheme: yet to decide ;D

Title: Re:
Post by: a3ruz on March 24, 2016, 12:33:21 AM

Maiden video ?
Also please rotate the pic by 90° CW

Title: Re:
Post by: a3ruz on March 24, 2016, 12:40:52 AM

Also sir can you please post close ups of the motor mount n landing gear , what's the material used for landing gear ?

Title: Re: Simple design easy to fly plane
Post by: abin cochin on March 24, 2016, 09:28:29 AM

it look like a ft tiny trainer ;D :headscratch:

Title: Re: Simple design easy to fly plane
Post by: Tanmay.mathur on March 24, 2016, 10:02:53 AM

Any reinforcement for wing ?

Title: Re: Simple design easy to fly plane
Post by: SI74 on March 24, 2016, 11:06:08 AM

@Tanmay, since only 225gm , it doesn't need.

Title: Re: Simple design easy to fly plane
Post by: SI74 on March 24, 2016, 11:14:41 AM

@a3ruz, landing gear= pushrod bent , attached to (screws)a plastic (credit )card , large enough to cover the bottom of fuselage, so that the impact of landing is evenly distributed without damage.
Motor mount= Motor attached to a square piece of balsa wood( strengthened by feviquik drops & then covered with Sellotape) with screws and then hot glued to fuselage.

Title: Re:
Post by: a3ruz on March 24, 2016, 11:29:46 AM

Thank you sir :)

Title: Re: Simple design easy to fly plane
Post by: Carl on April 08, 2016, 11:01:45 AM

nice low cost rc plane.

RC India

General Topics => Beginners Zone => Topic started by: SI74 on March 24, 2016, 12:28:09 AM