Alok, i think it is not nessesary to trim the bulk heads.. as it all are in it's shape..

  I trimmed them !!

Alok.. hows now..? finished..? 

slept at 12 am, woke up at 8 am and was planning to get ready for work suddenly one mouse delayed the whole plan by barging in my bedroom !!!!! was chasing it I wish VC sir's cat was here...

came to my workshop now at 1130 am 2 hrs late and hope to finish by evening !!!

Thanks alok for helping me out

excited to see it ... 

I will be using my skills generously...expecting a generosity in return !

Attached one half of the top plates...
will trim excess once all top plates are glued.

Hold it!!! Don't glue the deck - call me URGENTLY!

!!!...

Roopesh - we were too late but he is taking steps for damage control.............

going home for lunch...will resume in an hour.

Alok.. hows it now..? completed..? 

progress update... side plate and bottom to be glued then top will be cut open. correct me if Im wrong..

found a freely available local hardware store glue which glues balsa in less than 2-3 seconds..."SPEEDY Brand" costs 20/- more i.e. 60/- for a 20ml bottle as compared to the two glue bottles which cost 40/- each which came with the kit "FLEX KWIK"... One flex kwik bottle exhausted so hence the above discovery.

 

Looking good Alok!

started putty work..?

Sharing the progress update... Finished gluing the bottom and sides and top was cut open precisely using a table mounted jigsaw machine .

bought polyester putty 1 kg for 140/- from an auto paints shop as 1/2 kg tin is not available in my area... 

Before applying putty is it necessary to sand the whole hull's outer surface smooth???

For mixing putty I plan to use an old cdrom drives cover...or should i use sweetmeat plastic box??

applying putty from outside is mandatory I feel so after drilling hole for the stuff tube and the rudder axle tube.

nicely shaped.. kneed a little putty at a time, and apply it within a minute.. and mix again, and apply.. this putty will be hardened within two or three minutes.. 

Bought gloves and putty knife... started filling gaps using PU putty...here's a pic... will finish in a day or two...

Good job alokh . 

my name has only four letters "Alok" no offence meant.

bought 250ml anti termite liquid tin for Rs. 74/-, 1x 1inch wide brush for Rs. 10/-,1x1.5inch wide brush for Rs. 15/- and a Surgical Mask from a pharmacy for Rs. 10/- to protect my lungs from Putty dust and antitermite liquid fumes as instructed by Roopesh Sir...

What's the latest Boss?

Applied pu putty and gave anti termite treatment and now applying nc putty 2 more coats to go. In line are the following procedures- float test, leakage tests,order gears, gearbox housing design, brushed gear motor installation, caliberation, motor loading tests, improvisation, testing, improvisation till it becomes perfect. final step- painting