Hi all I am new in RC. I need a help. Recently I brought one RC car Issue is that I dont know how to link the transmitter and receiver, I am not able to control the car and yesterday it hit and front wheel get dislocated from a bull type screw, I like to know how can I replace the wheel back place help me..
Which car is it? What radio system are you using?
http://www.remote-island.co.uk/Categories/Cars/Ferrari_Enzo/Radio_Remote_Controlled_Ferrari_Enzo.htm this is the one I have
Once i brought this it cost around 60pound now they dropped the price to 15 pound :( seems they where closing the store. Do any one know which type of servo is using in it. Now my steering servo is not working.
It should be a standard car servo.
thanks iamahuman ,From where I can get this type of servo?
What price range are you looking at?
I am new here I don't know much about this. what will be the price range?
Also I saw every one telling some specification for servo I don't know the specification of my servo. I ordered one but it was too small for my car. I will post the pic of the servo tomorrow
please do that only then we will be able to help you
Sorry was busy will post the pic tomorrow..
Quote from: lloyd on October 18, 2012, 01:40:47 PM
Sorry was busy will post the pic tomorrow..
please ASAP.
attaching the images..
Servo..
I would like to know which servo (any specification?) will suit for this.
I think the servo is Victory Hawk VH-3810
Hi lloyd,
I am not an expert but according to picture of servo's, I googled it and found that your servo specs are
http://www.trademe.co.nz/toys-models/radio-control/parts-accessories/servos/auction-257036336.htm (http://www.trademe.co.nz/toys-models/radio-control/parts-accessories/servos/auction-257036336.htm)
Dimensions: 40 x 20 x 36.6mm
Weight: 38g (with wire and connector)
Operating Speed (4.8V no load): 0.12sec/60 degrees
Stall Torque (4.8V): 3.5 kg/cm
Temperature Range: -30 to +60 Degree C
Connector lead length: 27cm
Operating Voltage:4.8-6.0 Volts
This servo is the equivelant to a Futaba 3003 standard servo.
futaba s3003 commonly used for steering and throttle of 1/10 scale performance vehicles including nitro(according to the specs in above link).
Here is the link for compatible servo
http://www3.towerhobbies.com/cgi-bin/wti0001p?&I=LXH288 (http://www3.towerhobbies.com/cgi-bin/wti0001p?&I=LXH288)
You can google it for more options.
NOTE : I don't have knowledge for electronics, please take help from experts. I request to experts please correct me or give suggestions if I am wrong
All the best.
Thanks
Shailesh
Thank you Shailesh..
I would like to know is there any servo with this spec for sale in our forum?