There was a general crib about RC, at home looked around for a dual use and found one This is a robotic Sweeper. Kinda Vacuum Cleaner on wheels which cleans in all nooks and crannies of the house. it came with only a 600 mah batt which was not enough. modified the Lipolys with a adapter interface. now when i am at office, these lipoys are put to good use. 3200 mah gives a sweeping time of 45 min and 5000 vacuums the whole house. See how bright I am !!!

Nice mod Wing.Co sir.

Gusty sir where did you pick up the robotic vac and for how much? does it have some logic and nav, or it does job random around the house?

nice.. some hitec metal gear servos and a mambe moster kit and were ready for some serious fun!

ebay, it has four modes spiral out, square, z motion and random, in an hour it doesn't leave a place, appears doesn't do anything until you open the dirt box, you can even trail a static paper or a mop it wipes (Not as good as a good looking maid though) , jokes apart, worth it, fleabay jindabad

Hey,get a mamba XL and power it with 8s lipos      

@Anirban:The MMM would be tame compared to the Mamba XL in this.

nice idea, i will modify one for my colg project..... bingo.....

cool idea
just add a lipo monitor and battery stays healthy

good idea, i will add that, because i saw the batt got drained to some ridiculous 7 volt, gr8 idea, i'll put a beeper

2s or 3s?I couldn't find it in the picture.7V on 3s would render it un-usable,wouldn't it?

might be a 2s looking at the balance tabs.Am I right?

11.1 v 3s, after it stops switch it off and on again it starts all over, son kept doing it and drained the batt so much that it took a long time to charge,

but didn't it puff up or anything? 7 V is way too low for a 3s isn't it?

one side yeah, slightly, i guess frequent on/off did the trick, 7 v was a guess, i connected it and went away for flying.

wow... 3s at 7v? thats too low. 3s should be minimum 8.4-8.5v....