Quote from: sanjayrai55 on April 24, 2020, 10:33:56 AM
Cork board. Available at all stores selling wood/plywood etc

Thank you,  sir

Sent from my ASUS_Z01RD using Tapatalk

Took my scanner out today after a long time , the last time i flew this the the two small pieces of balsa broke as well as the locking pin for the hatch . The balsa pieces were replaced by matchsticks covered with paper tape and fixed with epoxy . The locking mechanism was screwed in place by drilling two small holes . I attached a spinner as well which was laying idle from a long time . General clean up was also done .

Changed the props from two blades to three blades , did a few cosmetic changes here and there .

  good show!

me too done some changes and put big props. Fpv ready
though this is done before lockdown

Quote from: manojswizera on April 30, 2020, 09:01:02 PM
me too done some changes and put big props. Fpv ready
though this is done before lockdown

Looking good Manoj!

Did some useful activity...

Brought all lipos to storage voltage,

Cleaned and oiled motors...

And some useless activity - organised the props (some brand new, some over 50 years old)

You should have got the LiPos to storage in the beginning of the lockdown! Now it's flying time soon  

Pic of lipos is 6 weeks old!

Then you should have posted it 6 weeks ago. It might have reminded/inspired some others (like me) 

@KK Iyer sir,
Where did you got thise motrolfly motors.
Are they still available in India?

Quote from: PRANAVK09 on May 21, 2020, 03:41:19 PM
@KK Iyer sir,
Where did you got thise motrolfly motors.
Are they still available in India?

It was a gift from Mr Vishal Rao, owner of Kinetic Hobbies, in 2014.
I think another gentleman on this thread also received one 

Don't know if still available.
For some reason Motrolfly site never gave specs of this particular model (DM2610 1200kv)

Regards