Main Menu

To buy first rc plane

Started by Deepankar Joshi, August 12, 2017, 08:27:13 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

Deepankar Joshi

prabal, sry to trouble you but at the flite test site the recommended motor is a 2200kv but the power pack at vortex rc has a turnigy motor of only 1400kv. will the plane fly with it?

swapnilnimbalkar


Deepankar Joshi

Flysky FS-i6 AFHDS 2A 2.4GHz 6CH Radio System Transmitter for RC Helicopter Glider with FS-iA6 Receiver Mode 2 
prabal can i get this.what does mode 2 mean?

swapnilnimbalkar

Mode 2 means throttle is on left side and mode 1 is throttle on right side.

prabal276

Yes, go ahead.
Mode 2 means that throttle is on your left .
You can adjust the other channels as you like.
Don't worry about the Kv. My explorer flies with 1200.

KALYANPRODHAN

Do you read the posts in
http://www.rcindia.org/rc-india-forum/the-rc-india-gems/

You may try by visiting of scratch built
http://www.spadtothebone.net/
http://www.spadtothebone.net/freeplans.htm
http://www.spadtothebone.net/SPAD/corocub/Corocub_1.htm
http://www.spadtothebone.net/SPAD/PDF/Ultra%20Spad%20Stick.pdf

But  specific advice.
1. Dont test motor to DC, it will be burnt. Connect with ESC and then only check.
2. Be careful of CG. Make glide test.

and also,
3. Test in simulator using simulator cable with Tx or analog joypad, before real flight.
4. Land on long grass to avoid damage to the plane.
Hope you will be enlightened with reading these..
We have to unite and to prove ourself to make indigenous products as well as marketing / Canvasing them. I'm sure we must achieve success if we try unitedly.

prabal276

Sir,
What I think is that SPAD's are a tad bit faster.
That's why I recommended a depron model to deepankar.

ashok 2010

Quote from: K K Iyer on August 13, 2017, 08:45:02 PM
@dipankar joshi,
Pardon me for repeating what I've often said on this forum.

If I wanted to learn to ride a bicycle, I could
1. Buy one and get some help/instructions
2. Build one from parts
3. Design a bicycle myself

Similar choices are available for entering RC flying.
Have to be clear about one's objective.
Learning to fly? To build? To design?
Do not confuse these three.

The best way to learn to fly RC (without pain) is:
1. Pay training fee and learn from an instructor on his model, with no expenditure on hardware
2. Use a proven combo of RC and model, with or without a friend to guide you.

Or you can experiment with alternatives, with different probabilities of success!
The alternatives can however provide a lot of joy, even if they fail to help you fly successfully!
Regards
Beautifully explained i have lot of experience from the last part"The alternatives can however provide a lot of joy, even if they fail to help you fly successfully!"