Any suggestions on ground tracking  ? Have to do it before the maiden 

Sorry if i'm wrong but isn't the prop put backwards?Sorry if i'm wrong

It's sending air in the correct direction!

Maybe it is backwards, and the motor is reversed

hehehe amazing work sir Iv'e made a delta too but scared to fly it as im not sure of the CoG (

need to make your plane a bit saavdhan...... else prop will not move???

I didn't understand??

After looking to images you have posted I guess Saurabh wants to say , increase distance between prop and ground.

Nice build !

Thank you Vinayak

There is about 2 inches of clearance

The photo was taken from the top

Would love to see median . Hope you are preparing for same this morning sir 

don't forget to give the wheels a few degrees of toe in... this should keep it running in a straight line

Sent from a potato using a lamp

Vinayak, the weather was unfavourable this morning  . Maybe tomorrow.

Aniket: yes, I do that. But the tailwheel being small it's always a little dicey 

Priyum! You were right 

And I was wrong 

The prop was on the wrong way. It was displacing air in the correct direction, but low!

Corrected it now.

Thanks for pointing that out 

Sorry for not having commented earlier. Neat build Sir - All the best for the maiden........

Thanks buddy

Sorry for being terse here Sir, but you know......................

I do know

Sent from my GT-S7562 using Tapatalk 2

Not a very good maiden

It's climbing near vertical. Too much power.  I will have to take off at about 2/3rd throttle. Have to check wing incidence too (how?)

Too much power for a light build? 2mm coro?

Yup. The Turnigy 2836 - 1500 KV SK3 cranks out nearly 400 W at full throttle

Nice build sir 

Thanks, Mahin

Hehehe no worries sir,aapse seekh ke aap hi ko bataya and is there any video for the maiden?

No video yet

Sanjay Sir,
I think the front wheel supports should be more stiff ( in static condition) !
A short metal piece in bottom with all 6 screw may serve the purpose.

Thanks

Kalyan-da

I removed the plastic screws before the maiden and put steel ones. It is very rigid now.

The main problem is it climbs almost vertical even at 3/4 throttle, and not being a very good flyer I get into difficulties and have problems controlling it. I am also not sure if the wing angle of attack (incidence) is OK. I was thinking of putting some packing under the TE.

What would you advise?