This is from plans on Outer Zone, and extensively adapted for Electric Power & Corro

Could only get 2.5 mm Corro in Yellow. So, lot of reinforcement will be used

Fuse cut-out

Time to build the main Landing Gear

3 mm Spring Steel

It's supposed to look something like this:

Building it in situ

Used binding wire, followed by epoxy steel

The bends in the cross-members give spring action. The Cold Weld is 16 years old, still works 

Excellent build sir!
Following the build!

Just look at that last pic of the undercarriage.
Its fantastic!

Another masterpiece in the making ..... Great going sir ...

Sir which Electronics you plan to use ?
Truely beautiful

Sir;
where did you get the tubes of cold weld?

Thanks Prabal, Iyer sir, Doc, Tanmay!

Iyer sir, I do trust the L/G will take the load and shocks

Tanmay: Standard Servos for Elevator & Rudder, probably 19 g MG for ailerons

Motor - planning a Turnigy G15 950 KV with a 12*6 prop
ESC - 60  HK

LG Plate 5 mm ply

Tail feathers- 2.5 mm Corro doubled, hinge is single

some issue in pics.... not able to see..... problem with me or something else needed.

Battery to go in from the bottom. Hatch cover made

Quote from: rastsaurabh on March 22, 2016, 10:44:06 AM
some issue in pics.... not able to see..... problem with me or something else needed.

Problem with you for sure

Firewall



Crutch cum battery tray (5 mm corro)

Standard Servos and pushrods

Sir!
SUCH a high speed build!
Kudos!
How does your adhesive dry so quickly? Mine takes over an hour!
Regards

Another thing;
Where do you get those push rods!
I am literally tired of searching alternatives.
I am guessing Hk
Regards