Hi everyone... wasaway from posting on the forum...( too lazy for it)

Meanwhile built acorocub and now working on an airbus a320...
The thing about this plane is that it is going to be built completely out of coro ( lack of availability of depron epp or high density thermocol...

Completed the wings section with reinforcement ( wooden strip caled neading in hardware stores)... also attached the edf mounts...

The beadig was too heavy so removed that and used coro again

A picture of the progress till now

Out of glue... meanwhile...getting busy with  pusher glider... will resume this build tomorrow...
Any sugesstions

Wing section almost complete.. added ribs
Please help me to decide which control surfaces should I include in my first airliner...
I will be using rcb6i

Not including shaklets due to difficulty of construction...
Took inspiration from many build logs at RCG
They all were in depron...
I have never worked with depron till now, so I built it with coro

It is built to 1:30  scale

Wingspan 45 inches
Fuse length 49.3 inches
Fuse width 5.18 inches

Weight of wing section 255 grams

No response from the members?

best of luck.
are u doing some thing about landing gear. 

No plans for retracts

if u go for fix.

are u u use hard wire or ready made reinforce plastic.
mine use umbrella wire for rear. and for nose cut from bicycle carrier  spring.

Fuse skeleton ready...
Having a difficult time making the skin

Picture of the wing...

Wing dihedral...

Fuse skeleton pic tomorrow

Fuse skeleton pic

The dihedral brace is coming out... any sugesstions for a better one?

Make one using 1/2 inch wood dowels, I used the same for my Glidiator's wings.

I tried using the beading strips but the glue doesn't stick satisfactorily ( or I don't clamp properly...)
I nailed one to another but? He next moment there is a crack on one of the strips...

Use 5 minute epoxy

Any brand name?

You should spend some time reading the posts on this forum before asking

Improvised the wing... dihedral brace is strong now... used araldite..
The problem was improper clamping and lack of patience..Now I made the fuse skeleton but I am unhappy with it...

Can I use pvc gutterpipe ( round big pipe) for the fuse...it will be heavier but more crash resistant
Any comments on this?...
It will also be a new spad model

Trailing edge needs to be stuck at ends
The control surfaces are added

Control surfaces... flaps and ailerons