Hello guys,
After taking advices from kk iyer sir and sanjay sir,
I have decided to build a 30" blu cub 2 plane from gene bond

Please give me suggestions and remarks

Cutout templates,

@nilharsh,
Did you get raw material and the electronics?
Which motor, esc, prop, battery?

Good going.All the best

Hello sir,
I haven't bought any electronics please sugges me,
I have used 5mm biofoam for plame

Thanks kiran

Well what is the wing size and what is the weight, I can suggest you electronics.

Hello rcnitesh,
My wing size is 30"
I will check the weight without any electronics and post

And weight without reinforcement and electronics is 95gms

Traced out parts on bio foam,

Do you have any electronics with you.

No,
I don't have Any electronics,
I'm buying a hk6ch tx rx and 2× 9g servos.

instead of the hk6ch get the rcb6i you won't regret it.
For servos of this size get smaller 5g ones.
battery get this http://www.rcbazaar.com/products/2461-wolfpack-white-900mah-25c-74v.aspx
motor get this http://www.rcbazaar.com/products/2398-avionic-m202820-kv1400-micro-brushless-motor.aspx
esc get this http://www.rcbazaar.com/products/2443-avionic-white-12amp-esc.aspx

Thanks nitesh,
I'm buying used hk6ch for from 1 member of rcindia

Is there anyone selling used rcb6i

I don't know about the HK or rcb Radio sets, not having any experience of them, but the other products suggested by Nitesh should work fine. Again I don't know how good they are, but I have used Avionic Motors, and they work well as per promised specification. Well researched RCN

Hello nitesh,
What about this
http://rcmumbai.com/index.php/product/cf2822-1200kv-motor-2/

Sir
How much flying time should I expect with this motor esc battery combination.

I think that motor on rcmumbai
http://rcmumbai.com/index.php/product/cf2822-1200kv-motor-2/
Uses more power,

Therefore buying the setup suggested by rcnitesh,
Thanks nitesh.
How much flying time should I expect with abovementioned combination.

Sorry everybody I forgot to put the link,
Blucub2 link
http://www.rcgroups.com/forums/showthread.php?t=532138

  now Back to work,
The instructions on the thread said to put a weight on the parts,
So was doing just that

I would like to ask one thing to experts,
the design of this plane was few years back, so motor mount in template is for geared dc motor ,
How should I make a motor mount for the brushless motor,

One more, can I use cycle spokes for reinforcement...

@nilharsh
Like this:
Three samples.
I doubt if you will need cycle spoke reinforcement. For what? Wings?

Yes sir for wings.

@nilharsh
Pl post pics of side view and top view of wing
Edit: and front view!