hello friends since weeks i wanted a flying wing...so finally i made 1 for my self this morning .i have made this in 4 hours of planning n building the whole plane is made from waste corro lying around my work table ....but i still have a doubt about it that whether it will fly or not ...EXPERTS PLEASE ADVISE AND GIVE SUGGESTIONS because its my first time dealing with flying wings..
I am planning to use
3.5 gm hk servos
a 800 mah 2s battery
a hk 25-30 amp esc
and this motor http://hobbyking.com/hobbyking/store/uh_viewItem.asp?idProduct=5431
please suggest me if any changes arer to be made and most important where will the CG for this plane lie?
Hey akky.. can you post a pic from the side to see the airfoil?
its a kfm 2
and the leading edge is rounded using blue tape
hey Akky,
nice built!!!! what is wingspan?
i am using same motor with 2500Kv on my 18" F15 & 21" Su47 both with 3s lipo and 10A ESC, but smaller prop 4x4!!!! for 2s lipo u may hav to use bigger prop, try using 6x4 prop.
i think 25A ESC will be little heavy, if possible try using 10A ESC
all the best for ur project!!!
cheers
each wing is 16" so 16"x2=32"
middle plate length =4 "
total span is 32"+ 4"=36"