After flying sanjay sir's junior100 me too got an itch to make it
And here's what i made

many many thanks to sanjay sir who helped me so much during this build ,infact a part of the build has been done in his workshop only.

Plans are from
https://outerzone.uk
length:820mm
wingspan:1120mm
Auw:950g
Motor:2836 1100kv
prop :10×5
Esc:40 amp
Battery:2200mah 3s 11.1v
Servos:2-9gram servos for wings
              2-14gram servos for rudder and elevator

Wings made from 3mm corro and ailerons from 4mm corrowith wooden spar

Fuse cut out from 4mm corrowith a 5°of downthrust and 3 to 4 degrees of right thrust markings (if you are aiming at fully flat bottom wing then i would recomend the down thrust to be just double with 5degrees of down thrust plane had a very high tendency of pitching up and stall)

i made two formers from 3mm ply wood and motor mount from 10 mm plywood

epoxied the former pieces and support for tail wheel and elevator.

Dry fitting elevator and rudder

Main landing gear

Scratch built tail dragger used 1.5mm aluminium sheet and 2mm  steel wire

Made holes in firewall to let the air cool the battery and esc

Servos and pushrods attached

finished fuselage

A picture with sanjay sir's junior 100

After some vinyls

Video of flight

 

Well done. Now plan the next - QB 10L

Very well harshit,
This is how things turn out , when you have some very experience and helping hand on you.

Quote from: sanjayrai55 on November 23, 2016, 05:38:08 AM


Well done. Now plan the next - QB 10L

thanku sir 😊 and yes i will try qb 10 after this semester exam

Quote from: manojswizera on November 23, 2016, 10:37:49 AM
Very well harshit,
This is how things turn out , when you have some very experience and helping hand on you.

Thanks manoj sir and yes sir i am really fortunate to get experienced and very helpfull  rcpilots to fly with

Very good build harshit 

  gaurang

nice built

Thanks samyaraj

nice build...... keep doing more models with coro....

  ramarao

Quote from: ramarao on November 26, 2016, 11:29:27 AM
keep doing more models with coro....

I will sir