Initial dimensions decided
Length 70cm
Width 52cm
Height 24cm
Propeller 8x3.8 sf (emp)
Motor avionic 1700kv
Esc avionic 20 amp
Battery wolfpack 900mah 25c 2 cell
Servo avionic 9 grm
Tx/rx avionic rcb 7x
All items are from rcbazaar pune store
Wooden spars for support
Design material 2mm coro sheet
Initial work done.
.
From where did you get the plans ?
@devangflyer
i am not going with the plan sir
this dimension come out from the past experience of eurofighter build
yet the dimension are not final i will trim the size as per requirement
if the project got success i will print all the sizes at the end of project
i am trying to build the model in coro sheet which is bit difficult due to the property of the material
this model should be made in foam
you can successfully build and fly it in that way and get all the plans from
parkjets.com/free-plans
also you can search rcindia.org for this model in biofoam
Okay . Happy building.
todays work
now you should consider building some real jets...
@topalle
did you mean duct fan jets
sure i will try
yeah edfs...
they're just awesome...
@topalle
Sir
I am already on the plan you talking about , once I pass this examination and fly this prototype well
I will move on to large size of edf looking fighter airplane , I already purchase the power plant(2500 grm of thrust) esc battery also
Just I need a duct fan and some success in my project I will move on
some body on facebook ask me what is the mach number of this airplane
;D ;D ;D ;D ;D ;D ;D ;D ;D ;D ;D ;D
frame work complited
electronics installed
ready to fly model
aircraft everywhere in my house on the floor also
Today I made the test flight of the eurofighter
When I was performing the throttle test prop hit my hand but that's happen when we teach our self
And forget sometimes about safety
My last build su 30 mki was under power, but this airplane got everything
I had flown my kishi trainer airplane successful and I enjoy it
But flying eurofighter was not easy task I was not able to hold this airplane in air for longer time because the control respond was so fast even Takeoff was not easy for me.
This aircraft can vertical climb dive , roll loop everything you want it can perform
This airplane is fast very fast
I build this airplane but I cannot fly this airplane until somebody teach me or
I train myself on such kind of simulator
the plane is not stable at all (it do not have dihedral as I use to fly everyday) once it roll it got inverted in fraction of time even just small elevator roll the aircraft.
I recommend this is expert aerobatic kind of airplane even this airplane is not for me
Tomorrow will print all the dimensions and modification before fight
flying inverted
vertical climb
few more
no change in the dimensions as above
only make changes to reduce the weight of the airplane
as seen in the picture.
Conclusion of the project
This kind of build in coro need lots of improvement.
It will be easy to made this kind of model with biofoam as coro structure need lot of work for strengthening , to compensate the weight And maintain the aerodynamic shape of the airplane , it can perform bad in air if the structure is not strong .
But this model is very fast.
Project is over thanks for support :hatsoff:
Good pics of the typhoon at different angles.
Yes you are right, depron or biofoam are better options for these types of plane. Make them light wt and they will behave much better.
FT F-22 is a very good plane and handles well.
:hatsoff: {:)} :hatsoff: {:)} :hatsoff:
Where do you fly sir ?