Wing cutout drawn on scrap piece and then traced to the fuselage

Formers and Firewall made.

Servo and horizontal stab cutouts made
Servo mount supports glued
Front former and firewall glued to one side

Fuse folded and formers and firewall stuck to the other side.
Balsa support installed for the horizontal stab to rest on

Landing gear block installed.
Wood to Wood -> Using Epoxy
Wood to Coro -> Cyano

Crutch cum battery tray

The battery tray rests on top of the landing gear block.

Wing glued in using hot glue

Horizontal Stab glued using hot glue

Vertical stab glued in

Landing gear attached.

Fuselage Top glued in place

Servos and Electronics installed

Coins taped to the front to balance the plane

Awsome build ... Absolutely clean ...
Eagerly waiting for the maiden

Ready to Fly

Final specs:
Wingspan: 42 inches
Length: 41 inchees
Wing area: 399 sq inch
AUW: 1355g (including 65g noseweight)

Electronics used:
Motor: Turnigy SK3 3536 1050kv with 12x6 prop (Measured 1800g of thrust)
ESC: Turnigy Plush 40A
Battery: 2200mah 20C 3S Lipo
Servos:
Ailerons - Emax 11g Metal gear servos
Elevator and rudder - Emax 19g Metal gear servos


Plane is VERY Heavy and has a very high wing loading.

At the field:

Flight videos:
NOTE: The video of the third flight is a complete video of the entire flight as required for the sweepstakes.
The first and second video are incomplete video.

Great 

Great.    Was this done from a plan .. Or you adapter it in coro .... Would definitely like to construct one ... Hats off

Getting the perfection in your build....
Nice and new plane in coro.

I took the dimensions of the Edge 540T from the FAI website, then scaled it down. Also made a few changes to adapt it to coro

The plane is very heavy and needs at least 70% throttle to fly level. It does the harrier pretty well and hovers at about 75% throttle so the thrust is enough, but the wing loading is very high.