My NASA UCAV crashed today morning which i made for sweepstakes-2014.
So immediately i started making F-22 Raptor to continue my participation.
Most of the parts are ready.
I will assemble them tomorrow.
Expecting test flight by tomorrow evening.
Remaining parts
I will assemble them following way.
Rudder
Wow ! I love the way you build it.
I will also start building a F-22 - just copy yours.I would like to know more about the dimensions and the electronics you've planned to use.
Wing span: 54 cm
Length: 75 cm
Battery: 2 cell lipo1500mah
ESC: 20 amp
8000 kv motor with 55 mm duct fan
OR
6 inch pusher prop.
will decide after weighing it.
Build photos
Build photos
And its ready to fly.
could not fly today because of high wind.
I hope i will be able to have test flight and its video uploaded before tomorrow 10am.
Very nice build. Neat and clean. Waiting for video.
http://youtu.be/CpOZZSVbyVY (http://youtu.be/CpOZZSVbyVY)
I dont know why motor stalled and lost the power during flight
on a beginner's request i m adding pictures of my pusher F22
The plans are for depron but i m using corrugated plastic sheet which can be easily stick together by quickfix as well as it has two layers of plastic so if we cut one layer carefull in line we can easily fold it at any desired angle.
i followed this plan for flat body.
lower part i followed original picture of f22
Hi , Saz
last picture shows lower part
Thanks for the plans!!! :)
i also use coro to build park flyer. finish is so far :goodjob:
Thanks
Pusher prop F-22: http://youtu.be/RX0WFrj7KBQ (http://youtu.be/RX0WFrj7KBQ)
See the stability of the plane in video.