After the corro spitfire, thought to build a minj jet. The F22!
Specification:
3mm corro
Wingspan-25inch
18 gram avionics motor
20amp esc
3cell 500mah lipo
8 inch sf prop
Started the build. Cutting out the main frame from 3mm corro.
Completing the fuse. Stuck everything with superglue.
Covering the bottom frame.
Tail fins added. (Vertical stabilizer) model is all set for mounting the electronics! :thumbsup:
Decals added ;D.
Added the servos.
Beautiful build kiran. it will fly great.
Quote from: manojswizera on July 25, 2015, 10:15:07 AM
Beautiful build kiran. it will fly great.
Thank you sir :-D
Landing gear made from cycle spoke.Used balsa to stick it on. :thumbsup:
Motor mount.
Motor mounted.
Pushrods installed. :thumbsup:
Making the canopy lock. The pieces lock into the frame.
The corro jet is all set for it first maiden flight :thumbsup:
Kiran a very good looking Jet indeed...Good luck for its maiden!!
Deepak
:thanks: Deepak sir, I will try to maiden it tomorrow if its not pouring down. ;D
Super looking! What weight did you get?
{:)} Great Build Kiran :hatsoff: looking good . Good luck for its maiden!!
Thank you Sanjay sir. :hatsoff: Didn't measure the auw but should be light ,with in 250-300 grams.
Quote from: a3ruz on July 25, 2015, 06:49:05 PM
{:)} Great Build Kiran :hatsoff: looking good . Good luck for its maiden!!
Thanks. :D
Sooooooo good.....
Awesome build bro.
:thanks: :thumbsup: Nitesh
Video. ;D
https://youtu.be/wTrXFpsRsoI
Great...!!
:thanks:
superb kiran u are doin great....
Thanks sir :thanks:
Which plan is this, nose section looks good..
It's from flight test.com
Awesome.....
I will also try this.
:thanks: Sure you may try it, is quite easy and fun. :)
I think Nose section will be difficult to make as a beginner.
Quote from: Suyash on September 03, 2015, 04:54:38 PM
I think Nose section will be difficult to make as a beginner.
It isn't that hard. Just a few folds.:)
Congratulations
:thanks: Vishal