Sravan came over , to take a break from my Giles 202 with JBA 15 CC gas engine project, printed, made template, cut and made FA-18 Super Hornet from Tomhe Plans (http://rc.tomhe.net/fa-18) , the idea to make one was mooted by Sandy (Sundaram Velar)

all this was 3 hr effort, two simultaneous cuttings, self & Sravan.

Maiden today

Electronics

2212/6 Rcforall Motor
6x4 Prop
2200 mah 3S Lipo
HXT 9 gm servo from VK
Cycle spokes for push rods
Only Elevon controls

Good Gusty    .
Now we can continue our aerial combat where we left of last to last sunday.

My service for painting the bird is open 

if she flies well, then FPV and Formation aeros, what say ?

Yes Sir Positive 

Foams From Foamybuilder (Ashok NG)

Thanks Ashok ,

Quote from: augustinev on November 14, 2011, 12:03:48 PM
Foams From Foamybuilder (Ashok NG)

Thanks Ashok ,

how you got it shipped from Bangalore ? Foam is hard to transport even within city!!

Great looking build, indecently even Ashok brought a FA-18 hornet made of yellow coro.

indecently or incidentally 

Now I owe an FA-18 Super Hornet to  Gusty     

Quote from: ujjwaana on November 14, 2011, 09:45:05 PM
Great looking build, indecently even Ashok brought a FA-18 hornet made of yellow coro.

The FA-18 which i brought that day was built with foam not with yellow coro

That sheet which m holding in my hands is my F/A -18. Will make it in Dec. Gusty sir did u maiden urs?. Waiting for review and video.

CG 5.6 Inch from the base of the fin, that is about 1/2 inch from where the wing changes sweep. i launched her with neutral controls and she flew like a charm, not even once i had to trim. putting up video

Here are some pics of the Hornet Flying

here is the short video

Great build
Sir what type of foam you have used to build this, and where we can get ? at what price.
Do u have plans for it.

Foams are from ashok NG (foamybuilder) from this forum, ask him for the price, approx 100 rs a sheet i think (I have a huge consignment of foams)