Hello;
To start off; ;)
i am really bad at build threads. They Often go In-Complete. ;D
So i am just reviewing this craft.
I have done a mix flight and review kind of video.
Please turn on the quality to 720p as the video (flight) is a bit poor. :giggle:
I am ready to answer any questions regarding the plane.
There you go:
( the voice is my father's. He guided me through the maiden and help me be cool and relaxed.)
https://www.youtube.com/watch?v=N5aWrSlmfRw&nohtml5=False
Tell me how my editing is.
Very nice {:)}
Quite a fast model
Thank you sir!!
Sent from my GT-N7100 using Tapatalk
Very good prabal ,
Nice pusher plane.
Thank you sir!!!!
@Prabal276, quite good video editing, but I have a suggestion. You may show a close up of the model and describe the electronics/ materials used ,in the beginning of the video, which would be a better start. And yes, the plane is really fast with that APC prop. Is anybody sitting there on the field where you landed?
@prabal276,
Well done. Maiden flight as well as maiden video. {:)}
Next:
Why does she go up and down, up and down like a roller coaster?
Possible reasons:
1. You are over controlling the elevator. (Quite likely) Be gentle. Relax.
2. You are over controlling the throttle. (Not very likely) once you reach treetop height, reduce throttle. See how much throttle is required to maintain level flight. As long as you do not move the controls too much, the power reqd will be much less than you think!
3. Check if the CG is farther back than intended.
Suggestion:
Forget about how to make good videos for the present. Take that up separately later.
Concentrate on flying smoothly. That's more important than an excellent video.
Let me know if you want to see sample videos to illustrate this point.
Well done again!
Regards.
very good prabal. {:)}
Thank you sirs!
Will reply to questions when i get back from school
Regards
Sent from my GT-N7100 using Tapatalk
Congratulations Prabal. Great work!
Well-done Prabal {:)} Hope you could post more pics of the build.
@ K K Iyer
Sir;
I was nervous. the plane was rocking up and down because my hands were jittery and no EXpo/ DUals were dialled in.
i would surely like to see those sample video clips.
Thank you sir's.
Thanks to S174; Girish sir; samlikespad; suyash;
K K Iyer sir!
hi prabal plz post some pics of your plane.. :)
Sir;
Please gimme time till evening.
Regards
" Is anybody sitting there on the field where you landed? "
Yes! there were some workers. They were pre warned and did not care to move.
I had to pin the plane down to the ground so that it does not hit them
That is a problem when your plane weigh 1Kg! If it falls on someone's head/ body from above (when you lose control ) , think of this when you fly in any field. Be extra careful!
@prabal276,
Here are two examples of no elevator input following launch.
Just throttle reduction after about 5 seconds (Fantasia), after launch at about 80% power.
Throttle cut at about 20 seconds (Sunbird), after launch at 60% power.
https://m.youtube.com/watch?v=2EuXrJBowpU
https://m.youtube.com/watch?v=C96oiT0ndgE
observed sir!
Nice flying field BTW
better than mine (railways ranjhi stadium)
To fly any pusher;
up elevator has to be given after launch to compensate for the initial imbalance caused by the weird motor angle.
It was advised on FT forums.
I just cant remember where
Which esc were you using .
Btw nice video.
Tanmay;
Esc was hobbyking 40A UBEC.
thanks!
Sent from my GT-S7562L using Tapatalk
Didnt u see the video completly?
Sent from my GT-S7562L using Tapatalk
Nope 2g vaccums
:salute:
P.S- its time for you to upgrade to 3G+
Too costly too much.
I would prefer to buy a servo instead of a 3g 1gb pack.
Okie. You could use one of your house wifis which u were mentioning.
Sent from my GT-S7562L using Tapatalk
nice video! man you are a great pilot but u need to chill man, it crashes then it does XP its not an expensive warbird or something even though it may feel like one ! after all scratch build stuff gives u more near crash experiences than anything else :P and like flitetest says "take it up a few mistakes high" {:)}
I will take it up a few 'mistakes' hih next time.
Thanks by the way.
Sent from my GT-S7562L using Tapatalk