Print Page - J3 Piper cub using biofoam

Title: J3 Piper cub using biofoam
Post by: Kantesh on July 06, 2017, 10:13:06 PM

Hi my friends this is my first airplane made by using bio foam 6mm

Title: Re: J3 Piper cub using biofoam
Post by: Kantesh on July 06, 2017, 11:35:49 PM

Full built

Title: Re: J3 Piper cub using biofoam
Post by: madaquif on July 07, 2017, 12:41:15 AM

that's a really clean build kantesh...... :thumbsup: :thumbsup: :thumbsup:

wondering what covering material have you used.??

Title: Re: J3 Piper cub using biofoam
Post by: wingmanbunty on July 07, 2017, 08:51:52 AM

nice

Title: Re: J3 Piper cub using biofoam
Post by: Kantesh on July 07, 2017, 09:56:41 AM

Yellow cello tape

Title: Re: J3 Piper cub using biofoam
Post by: Kantesh on July 07, 2017, 09:58:49 PM

In progress

Title: Re: J3 Piper cub using biofoam
Post by: prabal276 on July 08, 2017, 08:34:23 AM

Kantesh, I have a strong feeling that the pushrod will flex.
Make a housing for it.
Otherwise you will have in-the-air problems

Title: Re: J3 Piper cub using biofoam
Post by: Kantesh on July 08, 2017, 10:23:43 PM

Motor mount

Title: Re: J3 Piper cub using biofoam
Post by: wingmanbunty on July 09, 2017, 11:08:55 AM

nice going kantesh also looking good power pod. {:)}

Title: Re: J3 Piper cub using biofoam
Post by: Kantesh on July 10, 2017, 10:47:52 AM

Ready to go for first flight

Title: Re: J3 Piper cub using biofoam
Post by: wingmanbunty on July 10, 2017, 12:28:33 PM

Nice so fast build I want to buy such turnig motors where did you buy it how much thrust it has.

RC India