Made my own prop with balsa! Comparison with plastic one. Much less weight!

Weight comparison.

Prop mounted on gear.

very nice sir

So what is the final all up weight?
Amazed at the low wt you are achieving!
May need the plastic prop for efficiency though.
I have a hard time getting a 12" chuck glider to be under 10gms...
Best wishes.

Wow Nice build. Keenly following it 

Thanks Antriksh

@Iyer sir, till now 5.5g may be a little over 6g with glue
   Efficiency may not be a problem as the plastic prop may be heavier for 4mm         gearbox.I just tested with balsa prop its giving nice thrust.
Thanks again

Thank you Sundaram sir

Making my own actuator . I used Micro neodymium magnet, copper wire to make it.

Added wheels too.

   awaiting for flight eagerly 

Actuator added on tail of plane.

How does the actuator work?

Hello sanjay sir, there is a coil which acts like electromagnet in which there is a small magnet. It works on attraction and repulsion.

I meant what does it do? Will it control the rudder from your Tx through the Rx?

Yes it controls the rudder through TX.Just same as servo. Control on rudder stick.

 

Will it be proportional movement like servo or just flick.

and is it direct connection to RX ?

@rastsaurabh
The actuator is fully proportional just like servo moving each points. It flicks only when directly connected to power source.It is so proportional because of rx output. 

Yes, it is directly connected to rx which is capable of driving the actuator directly. The normal rx requires a converter to hook up an actuator. 

Almost completed. Used a larger gear and prop.Now its giving much better thrust compared to the previous one.:-D

Making the battery hatch. 1mm balsa.

Hatch completed.Mounting left.

Completed. 

Great work , what's the final AUW , and a close up photograph of the rudder actuator would be appreciated.
Regards

Here is the final auw.
And close up of the actuator.