Quote from: arun.sreelakam on June 28, 2015, 04:35:11 PM
What materal for pushrod?
And which receiver you are using??

I had a few spare pushrods, just like in skysurfer
Rx is Rcb7x

  manojswizera

Magnetic wing! Attaching the wing with neodymium magnets! 

Motor and gearbox with brushed esc.

Motor mounts.

Mounted the motor.

Covered the motor area with foam.

Base for magnetic wing attachment. Two washers pasted on balsa.

Base attached to the fuselage.

Trailing edge lock made using balsa.

clean,good

  Prabal

@kiran rc,
Really liked your gearbox arrangement. (And motor mount)
This is classic desi jugaad

We don't have to copy the Chinese model.
Make in India rests on 'desi jugaad by youngsters like you!
Keep it up.
Regards

@ K K Iyer sir, thank you very much for the compliment. Actually seniors like you, give the motivation and inspiration sir.
Thanks again
One more jugaad that is the brushed esc out of servo motor

Can you elaborate more on that subject.

@rcnitesh, do you mean the esc?

Desi Jugad Brushed ESC from servo motor control circuit is reversible if you keep POT centered.

For this model you can make it unidirectional by replacing the POT with a single qtr watt resister of same value between the two extreme pins and shorting the center pin to one extreme pins.

Nice build superb...... just becareful of auw, motor should not be underpowered....keep checking on weight and reduce as much as possible....wish you  all the best

Quote from: sundaram on July 02, 2015, 11:34:15 AM
Desi Jugad Brushed ESC from servo motor control circuit is reversible if you keep POT centered.

For this model you can make it unidirectional by replacing the POT with a single qtr watt resister of same value between the two extreme pins and shorting the center pin to one extreme pins.

Thank you for that!

  roman
The estimated auw is 35-40gram with 5" prop. Should give some nice thrust. 

vvvvvvvvv.good build....
its awesome
i hope that it flies good and wins you a price in the sweepstakes

Yes Kiran I am asking about the esc.

Prabal thanks you very much.   The thrust should be around 60 gram.

Quote from: rcrcnitesh on July 02, 2015, 06:15:57 PM
Yes Kiran I am asking about the esc.

The esc is quite simple. The control board from inside the servo motor is taken out with POT. The POT should be centered and it can be used as brushed esc. Only for micro pager motors. If connecting for a larger brushed motor 1 or 2 mosfets can be added. Current amp of this esc is less than 500ma

Thanks bro.
From where did you get the 7mm pager motors?