just got this one from pvn2000 (praveen),latest  from the multiplex range,just like any other multilplx kit assembly is a breeeze. planning to use the  following setup

battery- turnigy 3s 2200mah 20c
servos- HXT 900
Tx, rx- spectrum dx8
motor--

see the pics

make sure to press the carbon wing spar fully into the wing when gluing.  i am using thick ca

glue the Grp wing spar both sides of the wing.

looks like the SUPERMARINE SPITFIRE...!!! (atleast the wing design ).. a real WWII RAF fighter..

all the best for the build and madein

tnx rc wish

lightly sand the surface of the wing spreader plate for better gluing

fixing motor mount

gr8 going Santa
you are motivating me to take out my spitfire

gusty  you are the inspiration , master of build logs on RCI 

Super, waiting for flight report

Dog fighter comes with the rudder servo slot sealed, if you are not using it , ok.my suggestion is to open it install the rudder servo before gluing the fuselage. this will ease the work if you are planning to use it later.also you have to carefully cut the form to free the rudder

 for the hxt 900 servos first insert it into the nano servo adaptor comes with the kit , carefully glue it not to spread the CA over the servo

normally all multiplex products have same type of control horns,.aileron control horns of this are different, double check before gluing