My first build unfortunately crashed

Vigesh its a good build !!!

Congrats!!

Crash is a part of this hobby! My blue baby didnt even takeoff! learnt from the mistakes

All the best for your next model, put up a Build log if possible 

some more pic of how I made the dihedral

I made a simple styrofoam cutter using cell phone charger.

Hi Vijeesh,

I am also a beginner and building a Blue baby as my first attempt.

Details are :

Wing Span – 33Inch
Weight – 140 Gms ( With Out any electronics)
Motor – Emax 2215/09 , 300 Watt , Burst Amp – 28
ESC – Emax 30 A
Battery – 2200 mah – 35 or 30 C
Prop- 10 x 4.7 SF
Servos – Hextronix 9 Gm

I have not built my models very accurately as seen in your photos.So pl review and suggest, that it may fligh or not. Also let me know the reasons behind for Crash of your model, so I can take care of such issues.

Regards

Good buils M. 
Whats the cord , it seems 8 or more ?

Thanks Swizera.. you are correect, wing span is 8 inch

Mjet, you mean wing chord is 8 inch.

Sorry to mentioned wing span instead of Chord... yes wing chord is 8 Inch

VC , pl review , it may fly or not motor mount and servo is a great task for me, i dont found any space for servo in cockpit ( only 1 inch space )??

Hi Mohan

Please tell what are the reinforcements you have used. Any carbon fiber rod or bamboo skewer etc ? The build looks good. Just make sure the high stress areas like area around wing mounting dowels, undercarraige, motor mount are appropriately strengthened.

The model will fly if you balance it correctly. You can mount the servos outside on the side walls if you run out of space

Ankur

Absolutely agree with Ankur. You are building a flying model, not a scale model. If you don't find enough space within the cockpit, mount them outside on the fuselage and / / or cut a notch on the wing root and push it up. As long as it works and the baby flies - ki farak painda?!

Hi Ankur and VC,

Thanks for review and suggestions.

I have not used any reinforcement on wings and dowels ( Also not used in original post ).

Motor Mount – from 6 mm ply to be fixed in front of model with Hot glue or Araldite, motor will be mount with screws
Dowel – used 3 mm wire for this purpose and reinforced with hot glue , pl see the pictures
cross section of air foil ( 4 nos  ) under wings may be glued for strength as seen in some pictures , if you think OK.
Pl advise.
Thanks and Regards