hello everyone,


i bought skysurfer v2 from rc bazaar. after 2 flights the ESC (i.e. 20 amp) was not worked . so i changed it  with  30 amp.

again after 2 flight the motor was not run correctly it runs only for  1 or 2 sec. and stops and it breaks prop 4 times in mid air.
what is the problem with the model kindly suggest . and please suggest a GOOD MOTOR AND ESC also for sky surfer v2.

sir plss don't put prop which u got in skysurfer v2. get some good prop. if u bend the prop in ur hand it will broke. buy some good prop dont use which u got in v2 it is very low quality . and put good esc and motor. it will fly good

check rcbharat they have upgrade kit for skysurfer.

what lipo you are using?

wolfpack 2200 11.1 v 3s

Check for proper prop (Match for pitch and dia of the prop).
Always follow a few things about electronics.
1) Prop should be recomended for the motor. Lower dia/pitch can be used but not larger.
2) should be matched for Motor. ESC may be little higher but never lower.
3) Battery with C Capacity should be higher than ESC required.
4) check alignment of prop saver/adapter.
5) check AUW and motor power recomendation along with KV.

So, somewhere it is not matched. Please give us the electronics complete setup for finding the propbem.

Specification:
Length: 930mm
Wingspan: 1500mm
Flying Weight: 715g
Motor: 1950kv brushless outrunner
ESC: 35 A brushless
Servos: 4 nos of 9gms servos
bat.wolfpack 2200 11.1 v 3s