hi,
I have been flying the GWS Beaver (3 channel beauty ) for a while and now i feel it is time to upgrade.
Please advise what should be the next level of my Investment should be.
I have been eying a cessna 182 or 747......
what are the expert's opinion / suggestions
I won't point out a specific model and i'm not an expert but if I were in your shoes then I would go for any high winger 4ch RC plane.
Cessna Is a trainer model flys gud.... since u were flying 3 ch its surely an upgrade to 4 ch...... but the real question is a high wing or low wing....
Check out the model GEEBEE at hobbyking... Its a gud 3d model takes lots of beating... I have one... gud to learn 3d moves and stuff...
A 3D model immediately after a GWS Beaver :headscratch:
hi,
can someone tell me where can i buy a 4ch high winger trainer in india.
what is you budget ? you can get wasp from flyrc (pvn2000) it is a good trainer, gr8 build, flies well, add a JBA engine and electronics and you are good to go
my budget is around 4k, interested in a electric flyer
http://www.hobbyking.com/hobbyking/store/uh_viewItem.asp?idProduct=12944
Quote from: Sreedhar on April 18, 2011, 03:05:53 PM
Check out the model GEEBEE at hobbyking... Its a gud 3d model takes lots of beating... I have one... gud to learn 3d moves and stuff...
i didnt know that the geebee is a 3d model ??
Not sure about the RC one, but GeeBees seem to be considered a pretty bad model in general.
http://www.rcindia.org/chatter-zone/a-book-on-the-worst-150-aircraft/
Quote from: hangingtough on April 24, 2011, 08:40:30 PM
my budget is around 4k, interested in a electric flyer
What does this budget include? Airframe only, motor, ESC, etc. etc.?
Quote from: anwar on April 25, 2011, 11:19:22 AM
Not sure about the RC one, but GeeBees seem to be considered a pretty bad model in general.
+1, even for experienced flier it can give a real hard time
i agree
Quote from: hangingtough on April 24, 2011, 05:36:05 PM
can someone tell me where can i buy a 4ch high winger trainer in india.
i would strongly recomend the thunder tigre ABS ready 40. Costs 4500/-Available at RCfor all- Contact Model art for the local delhi dealer if you want to save on courier rates.
It is a real hardy model, takes a lot of punishment, good flyer. Much sturdier that balsa models.
Why not build a Simple Plastic Airplane Design ?
An scaled version in Electric? This is very durable for coro build. 4Channel and of course DIY.
Cost will be within your budget surely.
http://www.spadtothebone.com/freeplans.htm
But Electric or nitro? Want to see expert's comment?
do you want a scale aircraft or do u just want to move to a 4chan trainer ?... what ever u do go for a high wing