Dear all,

I have bought a F-18 blue angel in the kit format (without any electronics)

Do i need the servo extension cable and what should be the length

Wire sizes are : 150mm or 300mm

   *  Wing Span: 670mm
   * Length: 960mm
   * Flying Weight: 620g
   * Servo: 9g*5
   * Battery: 11.1V Li-poly battery
   * ESC: 30A
   * EDF : 64mm

If the servos are attached to the side of the fuse box on belly, the std 9g Servo cable should  not need any extension lead.
Any was a 15cm lead should be enough.

Other wise just tie a thread on the plug of the servo and measure what length you would need to reach the Rx.

Hi Hangingtough,

from where you brought the kit without electronics?

Regards
Dileep

I am in korea right now and it is easily available here

Check this out
http://www.rcschool.co.kr/index.php?pgurl=shop/sh_goods_list&ctpose=AAG&ctno=321

Quote from: ujjwaana on August 29, 2010, 09:09:58 AM
If the servos are attached to the side of the fuse box on belly, the std 9g Servo cable should  not need any extension lead.
Any was a 15cm lead should be enough.

Other wise just tie a thread on the plug of the servo and measure what length you would need to reach the Rx.

Actually many reason for not able to check myself
1. the kit is packed ( I am in korea and flying back to india)
2. There are no servos installed
3. I dont know the placement of the receiver
4. I am not sure of the wire routing.

so it is impossible for me to check Myself. so looking out a help from a jet experienced flyer

keep this in mind as a rule of thumb. 50mm = 2 1/8 inches so a 150mm connector will be 6 3/8 inch long plus connectors..