Quote from: utkarshg13 on September 07, 2014, 07:08:54 PM
@kplkum : everyone warned you for your airfoil and control surfaces. Not seen your video but could figure out what would have happened..
with essaargee: " there is no end to the learning curve and it is never too late to start, learn and earn by experiences . Keep forging ahead"

Sir it's balance is perfect and it's fly. Now I am facing motor problem.

And esc got heated very much.

Re motor problem in video, pl see this
http://www.rcindia.org/electric-power/quality-control/msg195483/#msg195483

finally this happen 
now i need a new esc..

sorry but felt like 
place an order for a new one.

Received a new 40a esc.

Do a ground test before mounting everything on your model again. Mount the motor somewhere with prop. Connect ESC to it. Check whether everything is solved or not. Do it for atleast 3-4 minutes changing the throttle after some time.

@kplkum

as flash player is not working on my pc so i havent seen the video , by seeing the airplane picture at
page 1 it seem that you put the esc inside the airplane

its my persional suggestion it is not necessary i put my esc at the windshild area of the airplane ie outside

so that the propeller air help little bit to absorb the heat of the esc  .

see my coro build anti stress machine.


overall you have design very good airplane , all the best with your new esc  

Yes it was inside. ...Thanks for suggestions.

Due to heavy wind it crashes. But no worries I will build again.

After some crashes and tries it flew awesome.  Video will be uploaded soon. Thanks for all friends for suggestions and help.

That's my 1st fly.

Hi today I fly my model again. But there is little bit wind so some problem I face in flying. I have a question. Can I use full throttle in air. If yes. ..then how much time I can use continues.
Thanks

Can anyone tell. ..

The motor is a huge power plant and I recommend to use 50A Red brick with it.
What prop you use with the motor ? Does it overloads the motor ? Prop is the first to check any power system for RC Plane.
If the power system is OK, you can use full throttle definitely.

I use 1060 or 1260.

Go for 1060 DD/SF prop. Dont use 1260 with 40A ESC. you can use full throttle.
Does 1260 used when the esc burnt ? I always go with 1.5 times of motor's max current limit for ESC.
And just below size for prop from recomendation of Motor so that it wont burnt even at full throttle. I keep ESC Inside of model as I know my design will not burnt.
What is AUW ?

30a esc brunt with 1260. 40a is ok it do not become hot.