hi guys
i m planing to going to airfield in bhondsi gurgaoan just for exprience

@Ritz
Follow the below pic for making  landing gear.

Some extra pic.

And continue...

are these rods r cf rod
i m not getting the concept of making this landing gear

Hello Shubham!


I just found something really helpful to you.

Follow the steps below to make a Landing gear for your avispad.


Step#1

Bend wire till it matches plans. Should look like the picture LG#1 & LG#2.


Step#2

Cut a few inch long piece of yardstick or wooden ply. Strap wire into place like seen in picture LG#3.
In the picture the white small plates are Dubro Gear Straps. But anything that secures the wire to the board can be used.


Step#3
Add a strip of wood, of width of the fuselage, to both ends of the yardstick.
Add wheels and pants and your done.(Picture LG#4)


Step#4
Attach with rubber bands doubled over like you attached the wing.
(Picture LG#5)

Copyright Note:

"All text, pictures, and graphics Copyright@2005 Charles Pirkey All rights reserved."

The pictures above are the part of STS Build guide downloaded here:
http://www.rcgroups.com/forums/showthread.php?t=372857

Hi, have you finished your AVI? I built one couple of months back and its still flying good. I start my flight day with this one and then move on to my Debonair.

My AVISPAD maiden:



My eDebbie  maiden:



With the limited experience I got from these two builds, I will be more than happy to assist you if you are still on the subject