@ashJR : Actually my initial cost of stickering was only Rs 91. But then i wasted a little here and there trying to match the camo scheme on the plane.Therefore i got a few more prints making it up to Rs150. So i had to actually cut away some pieces of the sticker as to bring a continuation in the look. If u notice carefully the wing section have three different sticker pieces. This will definitely work out a lot cheaper and easier than radium once. Do tryout and let me know. But the only thing is you will be compromising on more weight than the radium i believe.

what did you make the plane with?
you could have made it with foam which wouldn't have cost you much either
the stickering is awesome

Quote from: Jatayu on November 29, 2011, 10:22:40 PM
What will be the exact result if i used a motor suited for a 70mm edf in a 92mm edf?? Will it be able to handle the load as in the increased dia of blades??

If your 70mm EDF motor was 6S Lipo capable with less than 2000KV then it may run in 3S LIPO in a 90mm EDF. Other wise it will fry and smoke.

@ Rajiv!

That is foam if you didnt figure it out! it costed me 200 bucks including all the artwork.

@ sundaram sir,

Thanks for that info!  am working on it.