Hi all.

Finally she is ready for the maiden after 2 weeks of hard work. 

Build logs follows.

pics

pics

pics

pics

pics

Great job....

very nice do you have pdf plan ? And what electronics have you installed ?

looks like my flylite  

Great one Malay! Anand here!

Well done. 
As proposed by Rai saheb sometime ago, you now stand promoted to 9pm!

  nice

Hello wonderful results after JW 8pm....
Very nice built.

give a coat of fevicol for strength, Or cover with transparent packing tape.

Thank you Nayeem sir, Agent 47, Anand, Sahil, Iyer sir and Rai Saheb.. 

@Agent 47 :- No plans.. just made it by looking at funfly which i borrowed from a co-flyer .

@Saurabh :- Thanks. Which one to cover ?? Fuse or wing ?

Wing first - any crash landing may break wing into 2 ... since you have not used any spar for wings.

else use a thin bamboo stick chiseled into nice 5 x 3 mm or a CF rod as wing spar.

Saurabh Sir.

Wing has 1/2" wooden spar inside it. Also wing is made up of the kind of foam used in sky surfer, rather its much stronger than that.
I have covered half of the wing bottom and top with white drawing sheet with diluted fevicol too. Hope it will take the crashes.. 

Image attached.

Agent 47

Electronics are
Motor :- 2822 1200kv  (Emax)
Esc :30 amp
Servo :- 4x9gm (towerpro)
Battery :- Haiyin 3S 11.1V 1000mah 20C Lipo

Iyer Sir.

Almost copied all the aspects from Techone Funfly apart from the down thrust of the motor.
Is it going to affect the flying characteristics ??

If the wood piece shown in pic u call as spar then....  Spar is a reinforcement which runs three fourth of the wing. If the foam is strong then 👌   but then the second question....... Where did you get that kind of foam?
For down right thrust it's important if u have a big prop.....in your case 8 inch prop will be big prop

Saurabh sir.
Got it.. the spar thing.. 

That foam came along with a packing for an industrial UPS for our office. I always keep my eyes open for that kind of free thingies.. 
All my builds are from the foam collected from roadsides. For example the control surface for the aileron you can see is the red color one is coroplast from a Times of India ad.

Nice! !!
Regards,
Aman.

Thnaks Aman.

Maiden video. 

www.youtube.com/watch?v=PzJtqd_7uXI

Which foam or thermacol u used btw its fab

Sahil sir.

As i mentioned before.. the foam is like sky surfer foam material .. a bit more stronger rather than that you can say. Even i don't know the name of that material. it has slightly synthetic type finish.