hi guys

finished building and test flew it today 7.30am,

spec.

multiplex fox chuck glider
2 X DYS 3.7gram servos
one 9amp BL controller
10gram hobbycity motor (with prop saver)
5ch auto shift hitec receiver SC
Hyperion 400mah 7.4c pack
home made 4ch radio with futaba RF module  

now for some details

AUW of the model is 110grams and had two minor accidents (pilot error )

flight report:

1. due to poor build the two elevator half are slightly off and hence an bit of aileron effect !
2. the motor has more then required right thrust angle had been corrected by rudder but the model is very sensitive to trim
3. i already had two minor crashes but the 3rd flight was the good no problems encountered !
4. flight time was about 16min and then landed as the wind was picking up
5. oh the model starts to rock even with slight breeze at low passes

all in all I'm very happy with the model and radio worked fine without any hassle (pre-flight range check was done for 36 paces)

sahil

Great Mod Sahil!! looks great... the hinge in the elevator in the las t pics interesting. Looks like DIY. Would you ming sharing the making it!!

simple i used a staple No.3-1iM and covered with wire insulation, will try to post a drawing

sahil

Bravo!! The staple pin idea rocks!! did you consider using ball pen refils instead of Wire insulation ?

thanks and yes one can use empty refill from pens instead of wire insulation, will work good for bigger models !

sahil

Don't forget good old Youtube  

its not that good and wind was bit high.........................

sorry had a memory stick problem(to small 64mb) hence short clip !

Hi,


Very Nice..........

upload some more videos plz.

What is meant by multiplex model? and What is DIY means?

http://www.lmgtfy.com/?q=multiplex+model

http://en.wikipedia.org/wiki/Do_it_yourself

The power of Google/search