my skysurfer V3 crashed... motor shaft broken, so i want to change motor

iam thinking to use Turnigy D2826-6 2200kv Outrunner

can i use this motor in skysurfer v3,which prop i can use this motor


need your Valuable suggestions
Thank you
Ramarao

yes you can. use 6x4 Prop. 

6x3, 6x4, 5x5.
How did you manage to break the shaft on a top mounted rear facing motor?

@K K Iyer  sir

stock elevator and rudder servos didn't glued properly.....while flying suddenly both servos came out from glue...then its hit the ground invert postion doing some rolls.....

The Skysurfer v3 is utter junk compared to an easy star since the day I purchased it last year I was able to do barely one flight and its been downhill since then. RCB even exchanged one as I was a regular at their store but even the second Skysurfer v3 I got seems to have a defective esc and horrible build quality (glue parts need re gluing) esc wire is of very low guage etc. I have virtually packed it and its been in the box since last 8-9 months Sorry to Hi-jack your thread !

ordered motor from vibrant hobbies....
Can anyone suggest prop for Maximum thrust.....



Thank you
Ramarao

6x4

@manojswizera
Thank you

what is the maximum thrust this motor will produce with 40a Esc and 2200mah battery with 6x4 prop?

more than 800gms

I recently changed the motor, you should rebuild the motor mount to handle power and use 5x5 prop to avoid stalling.

@Mjet

can you please post your motor mount pic ,,,what is thrust you are getting with 5x5 prop


thank you

I have not measured the thrust, but on 6x4 prop I set the throttle at max 40% and still power is more than enough.so I will check on this Sunday and post the experience.

@Mjet
Thank you

how you made that motormount ....please give me some tips..

You need PVC Pipe and a coupler. Cut the pipe in desire length and coupler ( apx 10 mm) for collar.joint with CA and glue mount with hot glue. Drill as many holes you can drill in motor mount.rest pics are self explanatory.

@Mjet


Thank you very much for your suggestions...

just recieved motor, today i will build the motor mount...........

@Mjet

i tried to put the motor on old motor .its perfectly fitted on old motor mount....

can i keep the motor on old mount or is there any problem if i keep motor motor like this...

Its 👌 ok, try to fix motor mount properly, so it can handle vibrations and thrust. If possible, drill some holes, so hot glue can enter in holes and establish a strong bond with fuse.

Thank you .....


i will do that......