I am trying to program Hobbyking 30 amp UBEC . I turned on Transmitter then moved throttle to full .After that connected ESC to receiver . After few seconds , 4 same beeps sound then 4 same beeps sound but different from first one , then i move throttle knob to zero . Now , throttle and break should be programmed . But no response , when i increase throttle . Although , all servo's are working fine . Can anyone suggest if ESC is not programmed properly or ESC is bad?

No one is using Hobbyking 30 A UBEC!!!
Is ESC bad or else?

Resolved the isse? if not, is this 30A ESC with UBEC or just 30A UBEC? You may try with trimming the throttle down towards zero, then the ESC should be calibrated..

Link to UBEc is :
http://www.hobbyking.com/hobbyking/store/__15205__hobby_king_30a_esc_3a_ubec.html

Still not resolved ..

read the product manual.  you have to enter the ESC programming mode first. then wait for the series of beeps.

Quote from: aditya on July 20, 2014, 03:20:55 PM
I turned on Transmitter then moved throttle to full. After that connected ESC to receiver .

@aditya
Connect ESC to battery. Rx should already be connected.
Hope this helps.

Quote from: theleabres on September 17, 2014, 12:08:13 PM
read the product manual.  you have to enter the ESC programming mode first. then wait for the series of beeps.

Sir , As per manual , by turning on transmitter with throttle in maximum positiion , ESC should be in programming mode . After Making connection few seconds later , 4 same beeps sound then 4 same beeps sound but different from first one , then i move throttle knob to zero . But no movement in motor while all servo's were working . I also checked motor with other ESC , motor was working fine.

Quote from: K K Iyer on September 17, 2014, 12:25:38 PM

Quote from: aditya on July 20, 2014, 03:20:55 PM
I turned on Transmitter then moved throttle to full. After that connected ESC to receiver .

@aditya
Connect ESC to battery. Rx should already be connected.
Hope this helps.

Yes sir , I followed same . After turning  transmitter on , i connected battery to ESC . Receiver was already connected . Mistake in describing process .

@aditya
Try this:
Move throttle to zero during first four beeps

Please do a throttle range first. Connect ESC with throttle Zero and after the initialization beep move throttle to full let it acknowledge with beep move throttle to zero now next time you move throttle then its should respond.

Now you can move to programming mode by keeping the throttle up and connecting ESC to battery and change the required setting by following steps as per the attached image.

Have you connected the esc to the correct port in the rx? Channel 3, which is a standard afaik!

# Iyer sir & Sundaram Sir , Thanks  . Will follow your steps and let you know.
# Tantragna sir , esc bec connected to Channel 3 . Thanks.