RC India

RC Equipments => Electric Power => Topic started by: foolsworldus on December 06, 2014, 01:53:28 PM

Title: Brushed ESC Problem.
Post by: foolsworldus on December 06, 2014, 01:53:28 PM
I am trying to use a Turnigy Brushed ESC 30amp esc for powering two brushed motors on my boat.. till yesterday all was good.. I had tested the motors and esc while building the boat...but finally when the time came for water test i am facing problems with the esc. The motors start running as soon as I am connecting the battery as if it was directly connected to the battery. Irrespective of whether the transmitter is on or off.. I have tried looking over the net could not find any solutions...please help
Title: Re: Brushed ESC Problem.
Post by: sanjayrai55 on December 06, 2014, 02:04:09 PM
Check the servo wire and connection running from the ESC to Rx
Title: Re: Brushed ESC Problem.
Post by: foolsworldus on December 06, 2014, 02:06:50 PM
Sir I have done that.. the motor starts at full throttle even when the esc is connected to a lipo and all other connections are removed including the receiver.. its behaving as if the motor is directly connected to the battery..
Title: Re: Brushed ESC Problem.
Post by: sanjayrai55 on December 06, 2014, 02:11:00 PM
Seems like some short in the ESC. Do you have another ESC to check with?
Title: Re: Brushed ESC Problem.
Post by: foolsworldus on December 06, 2014, 02:12:14 PM
No Sir.. I don't have any brushed esc to check.. can this short be repaired..