Hi
can i use 10*4.5 prop on my MYSTERY A2212-6 2200KV BRUSHLESS OUTRUNNER MOTOR.iam Using 30Aesc.i

motor specs:
RPM/V      2200KV
No. Of cells        5-7Ni-MH/2-3Li-Po
Max. efficiency current      14 - 22 A (>72%)
NoLoad current / 10 V        1.4 A
Current capacity        28 A/ 60 s
Max. efficiency          0.75
Shaft diameter (mm) 3 mm
Weight with cables    47 g
Internal Resistance     45 mΩ
Dimensions(mm)       27.5x30
Recomended model weight :300-1000g
Recomended prop without gearbox   2xLi 7"x5",3xLi 5"x5",3xLi - heli
Remarks:   Ideal to work with our 20A ESC and 30A ESC For A2212/6 and A2212/10

Thank You
Ramarao.

No you cannot in Neither 3S Lipo nor 2S Lipo.

Hello Ramarao

There is no way you could use that prop on the motor. It will fry up.
You could use an APC 6x4 prop for descent thrust.

Sent from my GT-N7100 using Tapatalk 2

Thank you sundaram sir
Thank you RCbharat

although it is not advisable but i have used 10*4.5 and 11*3.8 on 2200kv running 2s 1000mah @ 30amps  .... on my scratch build nutball , motor was a bit worm with 10-15 min of flight at half throttle... but nothing went wrong so far.... had over 20 flights

may be its Ok with throttle management on 2s

Arjun did you mean spinning a 11" prop at 15000+ rpm..?
Can I know what amp it consumed and the thrust produced..?
I am using a 6" prop and 3s, motor getting hot under 15min...



Sent from my Canvas using tapatalk 2

yes, i was using a rc timers 2200 kv motor with 10 and 11  ( 10*4.5 and 11*3.8 ) inch SF prop on my NUTBALL 24'' Scratch build Nightflyer...
i was using a 30AMP ESC ....since i didn't wanted to spend money on this build i used what i had laying around ...

i don't about the amps consumed.... flying weight of the plane was 600 to 700grms .... since it was a nightflyer i used a different  battery pack for lights ( 3s 500 mah)
about thrust ... the plane took off at less then half throttle with in 5 to 8 feet ...flew it half throttle mostly and got 10 to 15 minutes of flight time.... motor was bit hot but nothing serious ...motor and esc are still just fine..
have some videos pictures will post it in ....