While taking the video,I have covered them with a cello tape.

may be the esc is short circut already , try another

I still feel that one of your connection to the motor is bad.
Do this; take out one motor connector and try again, if motor stops moving then re connect and take out other connector. Out of the three there will be one connector which will have no effect when disconnected. Resolder everything again on that wire.

ok

Today Vedant had come to my house to test the motor.
We found that some of the wirings in the motor had broken.
when we connected the motor and esc and the battery the esc got very very hot,and finally was in flames and burnt in front of us!

RIP esc

Please Guys

Quote from: ved on May 07, 2011, 02:28:05 PM
Please Guys

Please what

Damn!! RIPESC. But why did you connect it when you knew it had broken wiring

We found it later.

Ok! so whats the plan now. I guess you'll have to buy new motor and ESC, it wont be a good idea to risk another ESC on a broken motor.

Yes. I am going to buy a new motor and ESC

This is definately a connector problem! Just wish i had seen this earlier.
The exact same thing happened to me - i removed bullet connectors on all 3 wires and soldered directly to ESc and it worked fine. Remember if the motor wriggles ONE OR MORE WIRES ARE NOT GETTING POWER!!!

http://www.rcindia.org/beginners-zone/fried-motor/

My video is the same as yours

yes they are right, touching up of any 2 of the 3 wires of motor when the circuit is on, can lead to a bad damage of "esc". moreover if lipos are connected this might result in fire.....
plz be safe.........