Hey guys,
Specially roopesh sir jee, please i need ur comments..
I have http://www.hobbyking.com/hobbyking/store/__2069__hexTronik_24gram_Brushless_Outrunner_1300kv.html
now accidentally motor was dropped from table on floor. And one cable came out of the heat shrunk, i was like DEAD at that moment. But then i recollect all my himmat and took a at the wires..
Now this is what i saw, 3 wires that come out of motor (which goes to ESC) are connected to the windings properly, no problem with that. But the is one which has came out of that black heat shrink. The one which has came out have 3 copper wires together in it..
So now the question is?? is there any problem caused?? i tried to test run it and it seems to work fine. :( still worried :banghead: :help:
Satya, from your notes its not clear what is the current position.. so, please add a photograph here.. and if the motor is running nicely, nothing to worry.. and make sure the solder joints are sound.. if anything goes wrong dont worry..most of the time these kinds of motors are be in to DELTA config.. so, you will find at least three stranded wires for each branches.. check it all for any breakage.. and check the internal resistance of each coil set as same.. if anything broken inside, the resistance will be differ.. post a photograph.. and dont worry.. :thumbsup:
every thing is fine....! u are just thinking about the motor falling from the table....!! my motorn ( also engines) have come down like missiles from 200-300 ft... still survived...!
if u are so much worried just cut a piece of insulation tape and stick it over the wires....
do not fiddle more... or u may end up screwing a good motor...!
I guess mine is star because, i just saw the one which came out has 3 wires in it. But other 3 has single...
Satya..dont worry..its a STAR config.. so, its ok..
ahh thank u thank u :)