Hi i have a 3cell20c lipo working correctly.turnigy aero drive 1000kv motor with 18amp esc.flysjy ct6b .before my motor was working.but after a month now my motor dont starts.i thought there is some thing wrong with the tx or rx.but when i put a servo to throttle ch it works but my motor does not starts only esc is beeping.
Try consulting the manual for the ESC... the beep pattern reveals a lot of information. Maybe it just needs calibration.
Sir can u tell how to caliberate esc.btw my baterry showing 11.4volt now can this be a problem .coz my esc is pf 3cell
2 minutes nefore i again tried .this time it run and beeped as dong before.but now it runs even when my throttle stick is at bottom most position
Please calibrate. Your ESC manual should have instructions on how to calibrate. Calibration procedure varies across ESCs
I think your throttle channel at radio is in reverse mode, check it
if it is going on at the lowest level of the stick then either your channel is reversed or your trims are not set if not this then trouble shoot your esc